stellar labs Slider20, Руководство пользователя

Страница: 18 / 44

12 Slider20 Owner’s Manual
Stellar Slider20 Hydraulic Hooklift Specifications
Lifting Capacity: 20,000 pounds (9,072kg) gross weight evenly distributed in, or on, body.
Container Length: 13-foot through 18-foot (3,963mm through 5,487mm)from front A-frame to rear of skid rails. Longer bodies up to
20-feet may be accommodated if full dump angle is not required (may require special body-mounted or
extendable truck-mounted bumper and additional latches to meet the Federal Motor Carrier Safety
Administration (FMCSA) Rear End Protection regulation 393.86 and Securing Hooklift Containers regulation
393.134).
Maximum Dump Angle: 55°
Operating Pressure: 4200 PSI (29 Mpa)maximum.
Weight of Loader: Loader weight not to exceed 3,500 pounds (1,588kg).
Height of Loader: Loader height not to exceed 11.63" (296mm)as measured from top of truck frame to top of loader rollers.
Hook Height: 54-inches (1,372mm)from bottom of skid rails to bottom of hook bar. Loader must be able to pick up body 7-
inches(178mm) below grade when mounted on a truck with a 41"(1,042mm) frame height.
Hydraulic Pump: Direct-coupled high-pressure piston pump.
Hydraulic Control Valve: Hydraulic valve mounted directly onto the oil reservoir.
Controls: Dual manual levers with sealed cable actuators mounted in the truck cab to allow full feathering of all loader
functions.
Tilting Hook Assembly: Loader must have sliding type front jib section to provide a low degree loading/unloading angle. Hook to
include automatic mechanical safety latch which disengages only when the container/body is in proper posi-
tion to be picked up or dropped off.
Tilt Cylinder: Single 3-inch(76mm) bore with 1.5-inch(38mm) diameter rod cylinder. Cylinder must be double acting and
include dual integral pilot-operated counterbalance valves to prevent cylinder collapse in case of hose failure.
Tilt Section Operation: Loader must include a hydraulic lock-out device to prevent operation of the jib section while loader is in the
dumping mode.
Lift/Dump Cylinder: Dual 4-inch(102mm) bore with 2-inch(51mm) diameter rod cylinder. Cylinder must be double acting and include
dual integral pilot-operated counterbalance valves to prevent cylinder collapse in case of hose failure.
Dump/Tilt Interlock: Dumping must be accomplished through a rear pivot. Jib and dump sections must lock into a rigid full length
13"(330mm)wide frame with front rollers to provide support for the container while in the dump mode. These
sections form this frame without the use of mechanical latches which rely on gravity, springs, or container/body
mounted latches. The system must be protected from out of sequence operation.
Rear Body Hold-downs: Dual slide-through hold down devices mounted to the dump frame to secure the body to the loader through all
ranges of the dump mode. This must be accomplished without the use of steel springs and/or hydraulic/air cylin-
ders. They must allow bodies with different tie down locations to be loaded. Loader must be compatible with
containers manufactured to ANSI Z245.60 recommended standard for waste containers.
Rear Dump Hinge Pin: 2-inch(51mm) diameter type 304 or 17-4 stainless steel minimum.
Pins: All pins to be type 304 or 17-4 stainless steel.
Bushings: All bushings to be of the permanently lubricated variety.
Hoses & Hyd. Fittings: All hoses and fittings are to be SAE; metrics are not to be allowed. O-ring face seal fittings to be utilized wherev-
er possible.
Origin of Manufacture: Loader to be designed and manufactured in the United States of America.