stellar labs Slider20, Руководство пользователя

Страница: 22 / 44

16 Slider20 Owner’s Manual
1. Clear the truck frame.
a. The front plate of the base needs to be at least 6.00” behind the cab or any equip-
ment mounted behind the cab.
b. Note that the jib extends 4.00” in front of the front base plate.
c. Be sure to square the Slider on the truck frame and make certain that jib cylinder is fully
extended for proper measurement.
d. Visually inspect the truck and look for any potential issues. For example: Clearance
problems, cross member extending too high, insufficient room in front of the Slider for
tarpers, exhaust manifolds, etc., or insufficient room in the rear to allow for bumper
selection.
2. Set the Slider on the truck frame.
3. Shorten the truck frame to within 2” from the rear of the loader.
4. Install bumper.
a. See Government Regulations for acceptable placement.
5. Install tie down channels. (See Mounting Kit Drawing PN 41987 on Page 18)
a. Move anything on the truck frame that may be in the way of the tie down chan-
nels.
b. Using 5/8” bolts, washers, and nuts, fasten two (2) tie-down channels together with
the narrow faces toward each other. Do this with all of the channels.
c. Place a tie down channel on both sides of the base, within 2” of the front plate.
d. Place a tie down channel on both sides of the base, underneath the tabs at the
rear.
e. The final channels should be placed in the approximate position shown in the cor-
responding mounting diagram. The top of the lower channel should be flush with
the top of the chassis frame rail.
f. Using the channels as a guide, drill ten (10)
11
⁄
16
” holes through the truck frame.
Also, drill a
11
⁄
16
” hole in the rear tab to allow bolting of the rear mount.
g. Using 5/8” bolts, washers, and nuts, secure all tie down channels to the truck
frame. All bolts should be torqued to 160 ft-lbs.
h. Weld the upper tie down channels to the hooklift base. Use 5/8” washers to
space the channels up. Remove washers when finished.
6. Install tarper tower (If applicable).
a. See brand specific installation instructions.
Installation Steps - Basic Guidelines