Stellar Effects Modeling Solutions REFIT SIGNATURE Series, Руководство пользователя

Страница: 40 / 43

40
by using the MAIN LIGHTS buttons) and engage the Red Alert pulsing lights throughout
the ship. Note that the RED ALERT MODE sound is slightly different for each movie
mode. Press this button again to stand down from RED ALERT and return the ship to
normal.
PHAS
–
This button will fire the ship’s phasers in an alternating two light pattern.
Lights or lasers* may be installed at any ports desired, but all linked to PH1 and PH2 will
fire together simultaneously respectively.
PHO TORP
–
This button will fire the ship’s PHOTON TORPEDOES. If in TMP MODE,
the tubes will ramp up red and fire blue torpedoes as seen in the film. (Wormhole
sequence) If in the other modes, they will ramp up and fire red as seen in those movies.
DESTRUCT
–
This button will engage the ship’s AUTO DESTRUCT mode, so it should
be avoided unless there are no other alternatives. Once pressed, you MUST enter and
complete the proper code sequence to complete the AUTO DESTRUCT function. (Hint: if
you don’t know the proper sequence, watch the third film or the TOS episode “Let That
Be Your Last Battlefield” then look for the remote button with the “number” also shown
on it. “Destruct” button also works as part of the code…) Once the code sequence has
been properly given, the ship will begin the AUTO DESTRUCT sequence. (yes, it’s
supposed to be humorous… can’t actually blow up the model, after all! Just enjoy the
show!) Once the AUTO DESTRUCT sequence has completed, the ship will reset and
return back to the POWER UP/MODE SELECT menu and you can choose which mode you
want to restart the ship in. Once you press the DESTRUCT button, you MUST complete
the code and go all the way through the AUTO DESTRUCT sequence, so only press this
button if you wish to see the sequence and “blow up the ship!”

E-HULL
–
This button toggles the exterior spotlights off/on in the engineering hull
(secondary hull) of the ship.
NACELLE
–
This button toggles the exterior spotlights off/on in the ship’s nacelles.
SAUCER
–
This button toggles the exterior spotlights off/on in the ship’s saucer.
(primary hull)
NAVS
–
This button toggles off/on the ship’s navigation and formation strobes.
MAIN LIGHTS -/MAIN
-
This button will decrease/increase the
brightness of the ship’s interior lights. You may adjust this setting at any point after the
first initialization of the MOVIE MODE, even if before the ship’s startup sequence
begins, so the ship will start with the interiors at your chosen intensity. This function is
particularly useful when it may be preferable to reduce the LED intensity for
photographing your model.
VOL -/VOL +
-
Use these buttons to adjust the volume of the sound from the sound
card. Note: these buttons will not be available while the ship is in a timed effects
sequence.