Stellar Effects Modeling Solutions REFIT SIGNATURE Series, Руководство пользователя

Страница: 20 / 43

20
MAIN EHULL/M2
– This terminal is where the negative wire (GRAY) main interior lights for
the secondary E-Hull will connect. It is interchangeable with and will function the same as the
MAIN SAU terminal, but it is best to separate the two sections due to the amperage
requirements for the LED strips.
RCS THR/RCS
– This terminal controls the yellow RCS thruster lights at various points
throughout the ship. You will connect the negative wire (YELLOW) from the RCS thruster LED’s
and/or the harness tether wires from the Nacelles and Saucer B tether here.
PYL/PY – This terminal controls the pylon spotlights in the secondary E-Hull. Connect here with
an ORANGE wire connected to the negative leg of the components.
FWD NAC/FN
– This terminal is for the Forward Nacelle Spotlights on the front side of each
warp nacelle. Connect the negative leg of the LED’s to this terminal (or the harness terminal)
with a GREEN wire.
NECK/NK – This terminal is for the Neck Spotlights in the E-hull. Connect the negative leg of
the LED’s to this terminal with a BROWN wire.
NAC REG/RN
– This terminal is for the Nacelle Registry Spotlights in the aft section of the
nacelles. (For tips on how to illuminate the registries, see the section on Raytheon lighting)
Connect the negative leg of the LED’s to the terminal (or harness) using a PURPLE wire.
PLA SEN/PL
– This terminal controls the spotlights in the Planetary Sensor Array at the
bottom of the saucer. Connect the negative leg of the LED’s to the terminal (or harness
terminal) using a YELLOW wire.
BR SPOT/BR
– This terminal is for the forward registry spotlight from the Bridge that
illuminates the ship’s main registry markings on the top of the saucer. Connect the negative leg
of the LED’s to the terminal (or harness terminal) using an ORANGE wire.
EHULL SPOT/EH
– This terminal is for the side E-hull registry spotlights. Connect the
negative leg of the LED’s to the terminal using a YELLOW wire. (For tips on how to illuminate the
registries, see the section on Raytheon lighting) If using the Shuttle Bay Board, the rear
Raytheon light attached to the board there can alse be connected to this terminal with a
YELLOW wire. If you are not using the SFX Shuttle Bay Board, you can connect a standard LED
here with a YELLOW wire to the negative leg to illuminate the aft registry beneath the bay
doors.
WEAPONS LIGHTING SIDE:
PHA1/PH1 and PHA2/PH2
- These terminals control the phasers. The negative side of the
components you use (Lasers or LED’s) will connect here (or to the harness terminals) with
PURPLE wires. If you are using lasers, no resistors will be needed. You may connect as many
phaser ports as you wish to these terminals. Phasers will alternately fire from PHA1 to PHA2. It
really doesn’t matter which side fires first, but you are free to decide on your own if it is
important.