Stellar Effects Modeling Solutions REFIT SIGNATURE Series, Руководство пользователя

Страница: 19 / 43

19
Let’s take a closer look at each terminal and its function:
MAIN POWER IN/OUT:
GR
– This is the main GROUND (Negative) input from your main power supply wire
12V
- This is the main 12V Positive input from your main power supply wire
12V
(out) – This is an additional 12V Positive output terminal if needed.
PRIMARY INTERIOR/EXTERIOR/STARTUP
LIGHTING SIDE:
12V
- This is a 12V Positive output terminal. Use for any 12V positive (WHITE wire) component
connection. Except the positive wire from the Neopixels for the Forward Deflector and Impulse
Crystal and the positive wire from the lasers for the Phasers, (if using lasers) all other positive
wires for components will connect to one of these 12V output terminals using a WHITE wire and
proper resistor. (Included)
5V
– This is a 5 Positive output terminal. Use for any 5V positive (RED wire) component such as
lasers for the phasers and Neopixels for the deflector and impulse crystal. No additional resistor
is needed for those components if connecting to 5V.
GR – This is a GROUND (Negative) output. You should only need this for the Neopixels for the
deflector and impulse crystal. Additionally, you can use it for any light you want to be on
constantly, but understand that any lights connected (other than the Neopixels) will also be on
before the startup and initialization sequences as well as if the rest of the ship is fully shut
down. It is not recommended to use this terminal for anything other than the Neopixels.
MAIN SAU/M1
– This terminal is where the negative wire (GRAY) main interior lights for the
saucer will connect. It is interchangeable with and will function the same as the MAIN EHULL
terminal, but it is best to separate the two sections due to the amperage requirements for the
LED strips. If you are using the SFX Refit Signature Series lighting harness, the GRAY wire from
the B and D harness tethers will connect here.