Page 13 of 38
939504792 Rev D
Spanner Assembly
1.
Connect supports with brackets, and attach mounting
plates to supports with "B" screws as shown.
2.
Align pilot holes in spanner worksurface with holes in
mounting plates, and attach with screws as shown. Each
mounting plate should be attached to the worksurface(s)
with a total of six (6) "A" screws.
3.
Attach the tie plates between the spanner and adjacent
worksurfaces. The tie plates should be 1.0" in from the
front edge of the worksurfaces.
4.
Attach wire managers as shown on page 8.
1
3
2
HOLES FOR
SCREWS
HOLES FOR
SCREWS
HOLES FOR
SUPPORT
BRACKET
TABS
Bottom View of Worksurface
B
B
B
B
B
1.0"
1.0"
ALTERNATE TIE
PLATE POSITION
ALTERNATE TIE
PLATE POSITION
TIE PLATE
TIE PLATE
See diagram at left.
4
See page 8.
A
A
A
A
A
A
A
A
TIE PLATE
TIE PLATE
