1
2
Tethered System Assembly
1.
Assemble tether brackets as shown on page
27 in appropriate positions, measuring as
necessary. For any continuously connected
system of worksurfaces, all tether brackets
must be adjusted to the same height relative
to the panel frames, not relative to the floor.
Use the marks on the strap as a visual
guide.
2.
Begin at the interior corner. With the help of
a partner, place the corner worksurface on
the platforms as shown on page 28. While
one person supports the front of the
worksurface, the other person must attach
the worksurface to the brackets with screws
from below.
CAUTION: Do not place any weight on
any of the worksurfaces until the system
is completely assembled! A partially
assembled system may collapse without
the firm support of all of the properly
attached components.
Page 32 of 38
939504792 Rev D
SAME
SAME
SAME
