Steca TR A502 TT, Инструкция по установке и эксплуатации

Страница: 54 / 56

54
742.114 | 14.50
EN
15.2 Cable specifications
Mains cable
Mains cable type
External diameter of mantle
Conductor cross-section
Single strand (solid)
Fine strand (with core end sleeves)
H05 VV-... (NYM…)
6.5 to 10 mm (0.25 to 0.4 inch)
≤ 2.5 mm 2 (#AWG 14)
≤ 1.5 mm 2 (#AWG 16)
Diameter of the internal strain relief 6.5 to 10 mm (0.25 to 0.4 inch)
Signal cable
Sensor cable length
≤ 100 m (330 ft.), including extension
Sensor extension cable
Design
Cross-section of each conductor
twisted-pair conductors for lengths > 10 m (33 ft.)
0.75 mm 2 (#AWG 18) for lengths < 50 m (165 ft.)
1.50 mm 2 (#AWG 16) for lengths > 50 m (165 ft.)
Tab. 9: Technical data of the cables connected to the controller
16 Exclusion of liability
The manufacturer can neither monitor the compliance with this manual nor the condi-
tions and methods during the installation, operation, usage and maintenance of the
controller. Improper installation of the system may result in damage to property and, as
a result, to bodily injury.
Therefore, the manufacturer assumes no responsibility and liability for loss, damage or
costs which result from or are in any way related to incorrect installation, improper op-
eration, incorrect execution of installation work and incorrect usage and maintenance.
Similarly, we assume no responsibility for patent right or other right infringements of
third parties caused by usage of this controller.
The manufacturer reserves the right to make changes to the product, technical data or
installation and operating instructions without prior notice.
17 Legal guarantee
In accordance with German statutory regulations, there is a 2-year legal guarantee on
this product for the customer.
The seller will remove all manufacturing and material faults that occur in the product
during the guarantee period and affect the correct functioning of the product. Natural
wear and tear does not constitute a malfunction. No legal guarantee can be offered if
the fault can be attributed to third parties, unprofessional installation or commissioning,
incorrect or negligent handling, improper transport, excessive loading, use of improper
equipment, faulty construction work, unsuitable construction location or improper op-
eration or use. Legal guarantee claims shall only be accepted if notification of the fault
is provided immediately after it is discovered. Guarantee claims are to be directed to the
seller.
The seller must be informed before guarantee claims are processed. For processing
a guarantee claim, an exact fault description and the invoice / delivery note must
be provided.
The seller can choose to fulfil the legal guarantee either by repair or replacement. If the
product can neither be repaired nor replaced, or if this does not occur within a suitable
period in spite of the specification of an extension period in writing by the customer, the
reduction in value caused by the fault shall be replaced, or, if this is not sufficient taking
the interests of the end customer into consideration, the contract is cancelled.
Any further claims against the seller based on this legal guarantee obligation, in particu-
lar claims for damages due to lost profit, loss-of-use or indirect damages are excluded,
unless liability is obligatory by law.