Steca TK RW-2, Инструкция по установке и эксплуатации

Страница: 7 / 28

7
735.800 | 10.7
EN
4 2 3
1
LAN
AIR WAN
NOTE
*Applies only to wireless LAN operation: When using WPA/WPA encryption, the "AIR" LED may be unlit
after having booted the router if no communication takes place with the picture frame!

Power supply mains adapter plug
USB port for USB flash drive
USB port for data transfer
to the solar controller
Aerial connection
EZSETUP: The wireless LAN
interface is switched on or off by
pressing briefly. If the button is
kept pressed down for at least
5 seconds, the version number
display appears on the screen of
the picture frame. To prevent the
picture with the version numbers
from being overwritten within a
short period of time, the con-
troller should be in "off" mode
during the procedure.
RESTORE: Quickly pressing the
button triggers a reset of the
image generation. This may be
necessary if a cable is pulled or
becomes loose or a display error
occurs. Pressing the button for at
least 10 seconds will restore to the
default condition and all stored
data will be deleted.
LAN port: is not currently supported
with the special firmware for remote
displays.
LAN: is not used for firmware
for remote displays.
AIR: LED continuously lit: wireless LAN is active*
LED flashes: transferring data / receiving
LED off: wireless LAN inactive
4 2 3 1
LAN
AIR WAN
: LED continuously lit:
device ready for operation
LED flashes: device initialising
system
3 Casing overview of the router
WAN port: for connection to the LAN
port of the broadband router
WAN: LED continuously lit: WAN is active
LED flashes: transferring data / receiving
LED off: WAN cable not connected