Steca StecaGrid Control I1, Инструкция по установке и эксплуатации

Страница: 54 / 92

54 738.977 | 1149
EN
Display Type Description
OFF STANDBY ACTIVE
W/ m
2
k W h
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
Data Information on the set parameter, e. g. Output
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
Err 2 System message 2
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
02.40 Inverter 02 from System A signals error code
40
: The
grid voltage lies outside the normal working range of
230 V ± 20 %
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
Data Information on the set parameter, e. g.
ENERGY /W
(en-
ergy per week)
12.3 Error messages
Error messages are displayed as follows (in this case: Err 1 ):
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
The following table describes the error messages.
Error mes-
sage
Cause Remedy
Err 1
Open circuit or defect in the required
hardware.
Notify the installer.
Err 2
Open circuit or defect in the existing
hardware.
The inverters switch off when insufficient
irradiation is present. The monitoring unit
then regards these as no longer present.
However, these will become active on the
next day and will be detected by the moni-
toring unit as properly functioning inverters.
If a previously detected inverter can no
longer be detected after 48 hours, then the
monitoring unit regards this as a fault.
No error : The error message disappears
after the system has been manually
switched off and on again.
Hardware defect : When the error mes-
sage is permanently displayed then this
indicates an error in the Monitoring unit
the cabling or an inverter. Notify the
installer.
Inverter removed : If an inverter is
removed then replace this as soon as
possible.
Err 3
–
Err 8
Internal defect Notify the installer.