Steca StecaGrid Control I1, Инструкция по установке и эксплуатации

Страница: 45 / 92

45 738.977 | 1149
EN
Procedure
1. Switch off the monitoring unit at the main switch.
2. Use a screwdriver to remove the display unit

.
3. Position the transmitter

. The protruding part of the
circuit board fits in the lower part of the monitoring
unit housing. Switch on the monitoring unit at the main
switch.
4. Open the remote display (the receiver)

and mount the
display

.
5. Insert the batteries

.
When the receiver module is located within the range
of the transmitter, after completing the display test the
display shows the detected connection:
rF 1
.
After this the system configuration is displayed three
times (number of detected irradiation sensors, tempera-
ture sensors and inverters):
•
IRRAD
• TEMP
•
POWER
– Number of existing inverters (here:
02
)
After this, the display switches to Total energy .
6. Now bring the remote display to the desired mounting
location

.
7. Briefly pressing the button calls up new information,
whereby the status of the antenna symbol can be used to
recognise that the communication has occurred success-
fully.
–
The antenna symbol is displayed permanently: The
connection is ok and the unit can be mounted.
–
Antenna symbol flashes: No valid information is re-
ceived. Reception can be improved as follows:
• Move the remote display by 10 ... 20 cm.
• Mount the remote display much closer to the
transmitter.
Note:
The range of the transmitter is tuned to suit usage in
normal homes. Heavily absorbent walls or floors (con-
crete) can limit the range.
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m
2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W
OFF STANDBY ACTIVE
W/ m 2
kWh
C
IRRAD POWER TEMP ENERGY /D /Y /M /W