Stalgast 9730110, Инструкция по установке / Руководство для установщика, Страница: 16 / 108

- 16 -
EN
• Before operating the griddle, make sure that no flammable substances (bottles, papers) are stored near
the appliance or inside the compartment behind the doors).
• The device is equipped with a temperature controller that allows you to set the temperature of the plate
in the range from 100 to 295
o
C. The unit is additionally equipped with a temperature limiter set to 360
o
C
to protect the plate from overheating, which can happen if the temperature controller is damaged. After
the safety thermostat has been triggered, the appliance can be restarted after the plate has cooled down
and after resetting the safety thermostat - red button on the control panel.
•
The unit is equipped with an electric igniter (spark generator) to facilitate daily operation - starting the
main burner.
•
When the device reaches the desired temperature, the thermostatic valve cuts off the gas supply to the
main burner. After the plate temperature has fallen, the valve automatically opens the gas supply and the
temperature of the plate increases.
• It is very important to carry out the process of „burning out” the grill during the first use. This sho-
uld be done as follows (during the first connection):
• remove the insulation from the working plate, clean the surfaces with cleaning and degreasing
agents;
• turn on the unit and use the knob to set the temperature at 150
o
C
•
after heating up, wait about 20 minutes and turn off the grill
• the working plate is made of rust-prone steel with a high thermal conductivity; remember to pre-
serve the surface with oil/fat
• In another version the working surface can be chromed. That reduces sticking of the food to the
surface and makes cleaning easier.
• During frying, the temperature of the plate should be controlled by the temperature controller
•
The device is equipped with a removable container for waste oil, residues and garbage.
• To remove waste from the drawer, pull out the drawer and throw the contents into the trash.
4.1. Starting the device
To start the grill, turn on the control pilot light (control pilot prevents uncontrolled gas leaks and ignite the
main burner). To do this:
• Set the valve knob to the position marked with asterisk.
• Press the knob of the valve, start the spark generator while holding the knob in this position (silver button
No. 5 in Figure 1).
• Through control hole No. 1 in Figure 1 in the panel, check the operation of the pilot - the flame should
be lit with a bright blue color. Hold the valve knob for about 20 seconds to heat up the thermocouple.
• When the thermocouple is warmed up, the pilot flame does not go out - the unit is ready for use. If the
pilot flame goes out, return to the first step.
• Use the main dial to set the approximate plate temperature.
Position on the dial
Approximate plate temperature [
o
C]
1 100
2 160
3 200
4 215
5 235
6 260
7 295
• Once the set temperature has been reached, the valve cuts off the gas supply to the burner. As the plate
cools down, the valve engages the gas supply and activates the main burner - keeps the temperature
constant.
• To completely switch off the grill, rotate the knob to the dot position. The control flame will go out.
5. MAINTENANCE AND CLEANING
Before starting any maintenance work, disconnect the device from voltage.
Daily maintenance
involves cleaning the plate and emptying the waste drawer.
• Wash the steel plate and drawer with a cloth dampened with water with dishwashing liquid and then
wipe with a dry cloth and cover with a thin layer of oil.