17
Night Vision
This camera has built-in IR LEDs, which provides the camera with the ability to view images in
no/low light conditions. It is important to use the provided power adaptor (and not the Batteries)
when using the camera for prolonged periods in low light conditions, as the built-in IR LEDs will
drain the battery more quickly than regular daytime use.
Installing the Camera
NOTE:
If you are installing Cameras that did not come with the System, please see the Pairing
Camera section of this manual for details on installation.
Mount the camera to the wall: Mark the position of the screw holes
on the wall. Drill holes and insert 2 screws. Firmly attach the camera
to the wall by placing the stand over the installed screws and pushing
the base downwards to secure.
Position the Base holes (A) over the screws. Slide the base down
to lock the base in place.
NOTE:
The camera can also be placed on a flat surface, such as a
Table or Shelf, and no mounting hardware is required.
Adjust the Viewing angle of the Camera.
NOTE:
You can install additional cameras (maximum of 4
cameras).When adding cameras that were not included in the
original box; you will need to pair up the cameras with the receiver.
Refer to the camera pairing section of this manual.
Connecting Camera Power
The Camera can be powered either by using the provided Power
Adaptor, or using Batteries (requires 4 x AA type batteries, not
included).
NOTE
: Wireless cameras require a power source (either an electrical
outlet or battery power) to operate.
If you plan to permanently mount the camera in a location, it is recommended to use the included
Camera Power adaptor to prevent interruptions in the image, as using battery power is intended
as a temporary power solution.
Battery Pack
1. Remove the Battery Cover off the base of the Camera.
2. Insert 4 x AA Batteries (not included) into the Battery Pack. Make sure to correctly line up the
Positive (+) and Negative (-) terminals of the batteries.
Place the Battery Pack cover back on.
NOTE:
If the Camera is plugged in with the AC Adaptor, the batteries will not be used. The batteries
are intended for short term, portable Camera use only.
Power Adaptor
Connect the Power Adaptor to the Camera. Make sure the power adaptor is placed into a grounded
outlet or surge bar to protect the camera from power fluctuations.
Camera Positioning
The Camera can be placed on a flat surface, or wall mounted. The versatile stand allows for
several different mounting options.
A
