ST 500 "Piranha" Operation Manual: Software
57
Changing parameters
1. To edit a band in the list, select the corresponding table row, which will be highlighted blue.
2. Edit parameters:
initial (lower) and/or ending (upper)band frequency (fig.50, 4,5)
name or comment on the band (fig.50, 6)
tick highlighting on/off (fig.50, 2)
3. Press "Apply Changes" to save the changes, or "Cancel" to exit without saving changes.
Adding a new band
1. Set the cursor to the "empty" line.
2. Input band parameters:
initial (lower) and ending (upper) band frequency (fig.50, 4,5)
name or comment on the band (fig.50, 6)
tick highlighting on/off (fig.50, 2)
3. Click "Apply Changes" to save the changes, or "Cancel" to exit without saving changes.
Restrictions for band editing or addition:
1. The maximum number of bands (list rows) is 11.
2. The band should not exceed 600 MHz. If this condition is violated, a warning appear on the
screen:
"The band should be no more than 600 MHz!"
3. The value of the initial frequency must be less than the ending frequency. If this condition is
violated, a warning appear on the screen:
"Initial Frequency > Ending Frequency!"
Deleting a band
To delete a band, place the cursor on the corresponding line and click "Clear" and then confirm
the action.
Finishing
Save changes by one of the below methods:
download to PC's HDD by clicking the "Save to File" and specifying the path to save and the
name of the file (the list of mobile devices and information from other modes will be saved)
download only the information about the made adjustments of the ranges of mobile devices
in the memory of the ST 500 by clicking the "Write to ST500"
download information about all lists (in all modes) into the memory of the ST 500 by
clicking the "Write ALL to ST500"
