St. Croix Element-P, Руководство по установке и эксплуатации

Страница: 37 / 61

Element-P
37
The Combustion Fan Voltage may be increased if the vent system has long horizontal runs or
multiple elbows that slow the Exhaust flow down. Always check for creosote forming if the
voltages are increased
(See point 9 in the Troubleshooting & Frequently Asked Questions Section
in the back of the manual)
Flame Pattern Characteristics
Correct Flame Pattern - Bright yellowish-white flame with a brisk movement, having sharp
pointed end tips extending up towards the Heat Exchange Tubes while forming a fan-like shape.
Small amounts of ash and some live sparks being blown out from the Burn Pot area is considered
normal operation.
Incorrect Flame Pattern - Dark orangish-brown flame with a lazy movement, having black
smoky end tips curling up and over the Heat Exchange Tubes while forming a fireball-like shape.
Some Ash or Live Sparks not being blown out from the Burn Pot area is considered abnormal
operation. Extremely black soot forming on the ceramic glass surface is a sign of very poor
combustion (not enough combustion air) and should not be overlooked. At the other end of the
spectrum; an extremely brisk flame which blows large pieces of live coal out from the Burn Pot
area and causes stubborn shiny black build-up on the glass (too much combustion air) is also
considered undesirable.
If you experience problems adjusting the stove during the Break-In
Period, contact your dealer.
Thermostat Control & Pilot Settings
The Element-P may be controlled with a thermostat to help maintain a more constant
temperature. The Element-P may react a little slower to a thermostat compared to a Gas or
Electric Stove. With this in mind the low setting can be adjusted to increase or decrease the
amount of fuel used. This will allow the heat output during the pilot stage to be matched to the
size of the home. A larger home will require more heat than a small one. Keep in mind that the
Stove is constantly producing some heat that helps heat the home while it is in pilot mode. If the
home seems too warm, and the Thermostat is never calling for heat, a lower pilot setting may be a
better fit for the home.
(Read point 3 on page 29 for adjusting the feedrates on the low setting).
Running the unit in the T-Stat mode will also allow the unit to shut down once the Heat
Demand has been met.
Remember: Choosing a lower Pilot setting may require the Draft Fan Voltage or the
Damper to be fine-tuned to match the lower feed rate. Monitor how the Element-P is
operating after a change is made and adjust the damper or Combustion Fan voltage
accordingly.