SPX Waukesha Cherry-Burrell Votator II, Руководство по эксплуатации и обслуживанию

Страница: 48 / 84

Maintenance Waukesha Cherry-Burrell
Page 48 95-03057 October 2005
Heat Exchanger Tube Installation -
Horizontal Unit
1. Inspect jacket cylinder interior and wipe out all dirt
and impurities.
2. Lubricate sealing surfaces inside jacket cylinder and
install new O-rings in the tube.
3. Carefully insert tube into jacket cylinder. Support pins
of heat exchanger tube should be at 5 o’clock and
7 o’clock positions during insertion.
4. Push tube into cylinder as far as it will go.
5. Thread the eight (8) 3/8-inch bolts through the flange
of heat exchanger tube into jacket cylinder.
6. Tighten bolts in a crossing pattern until tube is
snugged down to jacket cylinder.
7. Torque bolts to 240 in-lbs (20 ft-lbs).
8. Install front cover.
9. Install latch hardware.
10. Install drive end head.
11. Install shaft (with mechanical seals).
12. Install opposite drive end head.
Maintenance of Vertical Votator II
DANGER:
Before doing any maintenance work
on the Votator II, lock out and tag out equipment.
Shaft Removal - Vertical Unit
1. Purge all product from unit.
2. Disconnect product piping from opposite drive end
head.
3. Lower arm of hydraulic lift so that arm can be
positioned under opposite drive end head. (See Figure
36, Item A).
4. Raise arm of hydraulic lift to just below opposite
drive end head (See Figure 36, Item B) and position
lift pin (See Figure 36, Item C) to go into shaft nut.
5. Raise arm so that lift pin is engaged in head and just
barely pushing against shaft nut.
WARNING:
Do not move latch or loosen nut
from locked position without hydraulic foot in
place beneath head.
6. Unlatch locking latch.
Figure 35- Install Tube to Jacket Bolts
Figure 36- Location Of Hydraulic Arm For Removal
Figure 37 - Disengaging Locking Latch