SportsPlay Bobbie 911-124, Руководство пользователя

Страница: 35 / 54

Page 35
Double Wall Straight Slide Plan:
The Double Wall Straight Slide attaches to the deck by bolting
through the Z plate and the deck sidewall. See the Top Down
View for placement.
INSTRUCTIONS:
•
Underneath the ‘foot’ of thee slide, there are two sets of
threaded inserts into which the slide legs attach.
•
Using your slide as a template, mark the ground holes
for the slide legs making sure that the holes in the Z
plate are aligned with the holes in the deck and the A
plate is at a 90 degree angle to the deck. Prop the ‘foot’
of the slide up and mark hole locations.
•
Dig one hole for both legs 12” wide by 20” long and
24” deep.
•
Connect the slide legs to the threaded inserts with four
3/4” x 3/8” button head bolts.
•
Place the bottom end of the slide with installed legs and
re-bars through the hole in the bottom of the slide legs
into the ground.
•
Carefully tip the top of the slide back onto the deck.
•
Make sure you ream the vinyl coated holes out (15”
apart) with a 1/2” metal bit.
•
Connect the Z plate to the deck with two 3/8” x 1 1/4”
button head bolts, no washer on top, and 3/8” washer
and lock nut on the bottom.
•
Place a level over the bottom to be sure it is on bubble,
block and level.
•
Install the slide guard and four clamps over the deck
entry on the “deck side” so that the top of the guard is
approximately 38” above the deck.
SPECIFICATIONS:
Event: Double Wall Straight Slide is 3/8” wall, rotationally
molded, 24” wide slide bed with 6” high side rails. Metal
brackets are powdercoated.
Paint shall be electrostatically applied oven cured powdercoat.
Hardware: Stainless steel tamper resistant
MAINTENANCE:
Touch up any marred paint surfaces.
Periodically check hardware for integrity and tightness.