Spirit P8Q67-M-DO, Руководство пользователя, Страница: 162 / 176

Spirit P8Q67-M-DO (Eng) Rev 1
150

Openings in the monitor cabinet are provided for ventilation. To prevent overheating,
these openings should not be blocked or covered. Also, avoid using the monitor on a
bed, sofa, rug, or other soft surface. Doing so may block the ventilation openings in
the bottom of the cabinet. If you put the monitor in a bookcase or some other
enclosed space, be sure to provide adequate ventilation.

Put your monitor in a location with low humidity and a minimum of dust.

Do not expose the monitor to rain or use it near water. If the monitor accidentally
gets wet, unplug it and contact an authorized dealer immediately. You can clean the
monitor with a damp cloth when necessary, but be sure to unplug the monitor first.

Place the monitor on a solid surface and treat it carefully. The screen is made of
glass and can be damaged if dropped, hit or scratched.

Locate your monitor near an easily accessible AC outlet.

If your monitor does not operate normally, in particular, if there are any unusual
sounds or smells coming from it, unplug it immediately and contact a service center.

High temperatures can cause problems. Do not use your monitor in direct sunlight;
keep it away from heaters and other sources of heat.

Unplug the monitor when it is going to be left unused for an extended period of time.

Unplug your monitor from the AC outlet before any service.

To reduce the risk of electric shock, do not remove cover (or back). No user-
serviceable parts inside. Refer servicing to qualified service personnel.
DOC Requirements

A shielded power cord is required to meet ICES-003 emission limits and also
to prevent interference to nearby radio and television reception. It is
essential that only the attached power cord be used.

Use only shielded cables to connect I/0 devices to this computer.

You are cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void your authority to operate the
equipment. This digital apparatus does not exceed the Class B limits for radio
noise emissions from digital apparatus as set out in the radio interference
regulations of Industry Canada.
This equipment has been tested and found to comply with the Industry Canada ICES-003,
Issue 2 Rev. 1, Digital Apparatus, Class B requirement. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or