Z100080
ZX-
1 Operator’s Manual
Spinergy/SMP
Page 21
IV.
OPERATING AND SAFETY
PRE-RIDE SAFETY INFORMATION AND INSPECTIONS
GENERAL SAFETY
Follow manual provided by your wheelchair
manufacturer. In addition to wheelchair
operator’s
guidelines, Spinergy recommends
the following guidelines for safe operation of a
ZX-1 equipped wheelchair:
1.
Study and obey all local pedestrian traffic
rules.
2.
Verify a path clear of traffic, and always
proceed with extreme caution.
3.
Always remember that wheelchair-height
pedestrians are difficult for vehicles to see
and operate the ZX-1 accordingly.
WARNING
•
The following safety checks must be read
and performed before operating the ZX-1
power add-on. Failure to comply may
result in injury to operator and damage to
equipment.
PRE-RIDE SAFETY CHECK / DAILY
INSPECTION
1.
Check tires and solid caster wheels: verify
tires and wheels do not contain flat spots
and are properly seated on rims.
WARNING
•
Maintain proper air pressure as shown on
tire sidewall in PSI/BAR/kPa at all times.
Do not under or overinflate ZX-1 tires.
Failure to comply could result in injury to
operator or damage to tires.
•
Inflate ZX-1 drive tires using regulated
air source with attached pressure gauge.
Failure to comply may cause tire to
explode and injury to operator.
2.
Verify pneumatic tires are properly inflated
as shown on tire sidewall.
3.
Verify ZX-1 power-up and battery level
displays green. If battery level displays
yellow or red, charge ZX-1 as necessary
before use.
WEIGHT LIMITATIONS
The ZX-1 operator weight limit is 250-lbs. The
wheelchair to be used in conjunction with ZX-
1 is also rated for a maximum weight capacity
as determined by the manufacturer.
