Gnome P. User Guide
The Record level control group-box allows you to choose the way to control signal
gain level: automatic (AGC) or manual. In the manual mode drag the slider to set the de-
sired gain level. You can disable gain control by dragging the slider to the leftmost position.
Scheduled recording is controlled by timers (1 to 5) which can be enabled in the
Record schedule group-box. Tick the desired timer(s) and specify recording start time
(date:month:year, hours:minutes) and duration time(hours:minutes). The minimum interval
between successive recording sessions should be 1 minute. To prevent manual recording
interruption by the voice-recorder switch, tick Ignore record switch. In this case scheduled
recording cannot be stopped manually.
Important!
It is impossible to specify a missing (past) start time on the timers.
The Voice Activation group-box allows you to enable automatic recording start at a
preset sound level (VA threshold). This threshold can be set within the 0…60 dB range; the
minimum step is 2 dB. Current input level indicator displayed below can be used for refer-
ence.
The Loop record group-box is used to enable loop record mode and set the desired
loop length (hours:minutes). Once the set time period has elapsed, new data will be recor-
ded over previous recordings. Thus, regardless of the overall recording session duration,
the amount of actually recorded data will correspond to the specified loop length.
In the Local erase button group-box the following functions can be assigned to the
voice-recorder erase button (N7 in Figure 5.1):
●
Use for playback
●
Use for erase
●
Locked.
To save current settings in a separate file on the PC hard drive, use the Save to file
button. To restore previously saved settings, press Load from file.
Maximum recording duration with current settings (hours:minutes:seconds) is displayed
in the lower part of the window.
To put newly set parameters into effect, press Save. To discard all changes, press
Cancel.
Pressing the Default button at the low left will restore the default settings.
Important!
All settings except date and time are stored in the voice-recorder memory regardless of
the power supply status.
If the voice-recorder was disconnected from the internal power supply (battery) for
more than one minute, date and time are to be set anew.
7.3.4. Working with sound recordings (playing, saving to disk, deleting)
All recordings stored in the voice-recorder memory with their attributes are displayed in
the Sound Manager Gnome P main window working area (see Figure 7.3.1).
18