Spectrum 1762sc-OF8, Руководство пользователя

Страница: 28 / 42

3-8 Chapter 3: Configuring the 1762sc-OF8 for RSLogix 50
User’s Manual Pub. 0300246-01 Rev. C
Output Range Output Value Condition Raw/Prop EU PID % FS
0.00 VDC Low Limit -32768 0 0 0
1 to 5V 5.50 VDC High Limit 32767 5500 18431 11250
5.00 VDC High Range 26809 5000 16383 10000
1.00 VDC Low Range -20853 1000 0 0
0.00 VDC Low Limit -32768 000 -4096 -2500
3.4.2 Output Data File (Normal Run Mode)
The output data file is used to configure each channel for the OF8 as well as
control the output signal of each channel. Use the addressing scheme shown in
Figure 3-2 above.
In normal run mode, output words 0 through 7 control the analog output signal
for channels 0 through 7 respectively. See Table 3-1 above.
Section 3.5
Module Status
Input data for the OF8 consists of status information, channel configuration
information and module configuration status.
3.5.1 Input Data File (Command Mode)
In command mode, the input data file returns module configuration status used
during the configuration process. Refer to section 3.4.1 for more information
regarding command mode. Use the addressing scheme below to locate the 8
input words.
Figure 3-3 (Input Addressing Scheme)
1. I/O located on the controller (embedded I/O) is slot 0. I/O added to the
controller (expansion I/O) begins with slot 1.
The layout for the input data file is shown below.