Spectralink 80-Series Handsets Administration Guide with SRP
1725-86030-000_G.docx
October 2013
17
Startup Sequence
The handset goes through an initialization sequence at startup. The line icons
1
through
9
display and count down as the handset steps through this sequence. This is usually very rapid.
If there is difficulty at any step that prevents initialization from continuing, an error message will
display and the related icon(s) will stay on. Please see the
Handset Status Messages
table at
the back of this document for instructions on how to handle error messages that occur during
initialization.
Icon
The icon(s) shown in bold turns off when:
12345678
9
The handset has located and authenticated and associated with at least one AP, and is
proceeding to bring up higher-layer networking functions.
1234567
8
The handset is either configured for Static IP, or if configured for DHCP the DHCP
discovery process has started.
123456
7
If DHCP is configured, a DHCP response was received which contains a good DNS
server configuration.
12345
6
Indicates one of the following possibilities:
1. Static IP configuration
2. SVP Server address found in DHCP option 151 response
3. SVP Server address found via DNS lookup
1234
5
All networking functions are complete (notably, DHCP), and the handset is proceeding
with establishing the SRP link to the Spectralink 80-Series Telephony Gateway.
123
4
The SRP link is established, all network stack initialization is complete, proceeding with
application-specific initialization.
12
3
The link between the handset and the Spectralink 80-Series Telephony Gateway is
established.
1
2
At least one IP address for a PBX (DHCP Option 128) has been identified.
1
The wireless telephone has successfully registered with the PBX.
(no icons)
EXT. XXX
Initialization is complete. The handset is in standby mode ready to receive and place
calls.
