Spectra 1759MG, Руководство по системному программированию и справочник SCPI

Страница: 28 / 40

Spectra 1759MG - 28 - Programming Guide
User Operation
Partitioning
The Spectra system is equipped with a partitioning feature which can divide the alarm system into two distinct areas identified
as Partition 1 and Partition 2. Partitioning can be used in installations where shared security systems are more practical, such
as an office/warehouse building.
If the system is not partitioned, all User Codes and features will be recognized as
belonging to Partition 1.
Programming Access Codes
User Access Codes are personal identification numbers that allow users to enter certain programming modes, arm or disarm
the alarm system as well as activate or deactivate PGMs. Spectra security systems support the following:
System Master Code can arm or disarm any partition using any arming method and can create, modify or delete any User
Access Code. Only the System Master Code can modify or delete User Access Codes assigned to both partitions.
Master Code 1 is permanently assigned to partition 1 and can be used to create, modify or delete User Access Codes that
are assigned to partition 1.
Master Code 2 is permanently assigned to partition 2 (except when partitioning is disabled, Master Code 2 will be assigned
to partition 1) and can be used to create, modify or delete User Access Codes that are assigned to the same partition.
45 User Access Codes (including 1 Duress code)
How does a partitioned system work?
• Users can only arm or disarm their assigned partitions.
• Only zones assigned to Partition 1 will arm or disarm when Partition 1 is armed or disarmed.
• Only zones assigned to Partition 2 will arm or disarm when Partition 2 is armed or disarmed.
• Zones assigned to both partitions will arm when both partitions are armed and will disarm when
at least one disarms.
• Some of the system’s features can be programmed separately for each partition.
How Do I Program Access Codes?
1) Press [
ENTER
]
2) Key in the [
SYSTEM MASTER CODE
] or [
MASTER CODE
]
3) Key in 3-digit [
SECTION
] (see User Code Table)
4) Key in new 4- or 6-digit [
ACCESS CODE
]
[
ENTER
] flashes. Return to step 3
How Do I Delete Access Codes?
1) Repeat steps 1 to 3 (see above)
2) Press the
[
FORCE
] key once for each digit in the access code (4 or 6 times) until the
keypad emits a Confirmation Beep.
User Code Table
Section User Codes
[001] User Code 001 = System Master Code
[002] User Code 002 = Master Code 1
[003] User Code 003 = Master Code 2
[004]
TO
[047] User Code 004 to User Code 047
[048] User Code 048 or Duress Code