Spectra Watermakers Catalina 340 Z, Инструкция по установке и эксплуатации

Страница: 21 / 90

21
Product to tank: Route the product water into the top
of a vented tank, or a tee in the water tank fill hose.
DO NOT feed into a vent line, manifold, or into the
bottom of the tank. Bladder tanks will create too much
back pressure. There must be no restriction or back
pressure whatsoever in this piping.
Salinity Probe
Diversion Valve
The 1/4”(6mm) product water tubing is pre-plumbed from the membrane into the electric di-
version valve. The diversion valve will reject product water into the overboard brine stream
until the MPC-5000 control determines the product water is below 750 PPM salinity. Once be-
low 750 PPM, the MPC 5000 control opens the diversion valve and product water is diverted
into the fresh water tank. The salinity probe must be mounted in a vertical position with the
cable coming out the bottom. If the Clark Pump/Membrane Module is mounted vertically or
upside down the diversion valve/probe assembly MUST be remounted in the proper orienta-
tion.
For plumbing to the fresh water tank,
see the John Guest fitting assembly diagram on the next
page.
Product Diversion Valve Manifold
Rotoflow Meter
Accepted Product
Water Outlet
Rejected product outlet
Product from membrane
Check Valve
Product Water Plumbing