Spectra Watermakers Bimini 300, Инструкция по установке и эксплуатации

Страница: 50 / 78

50
Membrane Cleaning Procedure
Spectra cleaning compound (SC - 2 or SC - 3) must be mixed with fresh water at a ratio of 1 container of
compound to 3 gallons (12L) of unchlorinated water. A Bimini 300 system requires one container of com-
pound per cleaning.
1. Close the intake seacock.
2. Push the Fresh Water Flush button to fresh water flush the system. Perform a second fresh wa-
ter flush in the same way.
3. Remove the quick disconnect fitting from the brine discharge outlet of the Clark Pump, and re-
place it with the quick disconnect brine discharge service hose. Lead it into a 5 gallon (20 liter)
bucket. Push the Fresh Water Flush button and run the feed pump until one gallon of fresh wa-
ter runs into the bucket from the brine discharge service hose. Press Stop .
4. Remove the hose from the “ To Strainer ” pigtail and install the inlet service hose from the service
kit. Lead both hoses into the bucket.
5. Make sure that the pressure relief valve on the Clark
Pump is open (un - pressurized).
6. Mix the cleaning chemical in the bucket. If possible, heat the
solution to 120 F (49 C).
7. Move manual switch on the Feed Pump Module to SERVICE
SYSTEM. The intake service hose will draw solution from
the bucket and the brine discharge service hose will return it.
Circulate the solution through the system in this manner for
45 minutes. Stop the pump by moving the toggle switch back
to ‘ RUN AUTO ’.
8. If the solution cannot be heated, allow the solution to sit over-
night before proceeding to the next step.
9. Replace the brine discharge overboard hose and run the pump until the bucket is empty by mov-
ing the manual switch to ‘ SERVICE ’. Return the switch to ‘ RUN AUTO ’.
10. Follow the New System Startup procedures to flush the chemicals out of the system (DO NOT
CLOSE the pressure relief valve!)
11. The system may now be restarted, flushed, or stored.
Connecting brine discharge ser-
vice hose
Removing hose to sea strainer
from the “ to strainer ” pigtail.
Attaching intake service hose to
the hose connecting to the sea
strainer.