Spectra Watermakers Bimini 300, Инструкция по установке и эксплуатации

Страница: 28 / 78

28
Note: If you must stop the purge sequence for any reason, the control will default back to the
beginning of the purge mode to protect your system.
5. After the purge sequence the display will alarm with the message “ Close pressure re-
lief valve. ” Close the valve and proceed by pressing Ok to resume the Purge Cycle.
If the system is new from the factory, or stored with Propylene Glycol, additional purging time
may be required.
6. The system will now run under pressure and
desalinate water. This mode diverts the product water
overboard in case there is any residual chemicals in the
membrane. Carefully inspect for leaks over the en-
tire system! Shut down the system and repair any leaks
you find.
Check the strainer and the brine discharge for water flow. The system should fully prime with-
in 60 - 90 seconds and all air should be out of the feed water hoses. The feed pump will sound
smooth.
There should be no bubbles anywhere in the intake hoses. If the feed pump continues to
sound rough, find the reason before continuing! Inspect the system for leaks.
4. The system will start purging and the display will
show the progress and time remaining
New System Start - Up and Testing continued...
7. After the Product Purge cycle completes, the system will prompt to Restart , then advance
to the Main Menu. If this is a NEW INSTALLATION, continue to the Calibration In-
structions to finalize the installation. If you are putting your watermaker back into ser-
vice, your system is now ready for use.