Spearhead TWIGA
120
7
7
7
7
GENERAL INFORMATION
GENERAL INFORMATION
GENERAL INFORMATION
GENERAL INFORMATION
Always read this manual before fitting or operating the machine – whenever any
doubt exists contact your dealer or the Spearhead Machinery Service Department
for advice and assistance.
Use only Spearhead Machinery Genuine Service Parts on Spearhead Machinery
Equipment and Machines
DEFINITIONS
– The following definitions apply throughout this manual:
WARNING
An operating procedure, technique etc., which – can result in personal injury or loss of life
if not observed carefully.
CAUTION
An operating procedure, technique etc., which – can result in damage to either machine or
equipment if not observed carefully.
NOTE
An operating procedure, technique etc., which – is considered essential to emphasis.
LEFT & RIGHT HAND
This term is applicable to the machine when attached to the tractor and is viewed from the
rear – this also applies to tractor references.
IMPORTANT:
During the initial ‘bedding in’ period of a new machine it is the customer’s
responsibility to regularly inspect all nuts, bolts and hose connections for tightness
and re-tighten if required. New hydraulic connections occasionally weep small
amounts of oil as the seals and joints settle in – where this occurs it can be cured
by re-tightening the connection – refer to torque settings chart below. The tasks
stated above should be performed on an hourly basis during the first day of work
and at least daily thereafter as part of the machines general maintenance procedure.
