Spearhead TWIGA
120
10
10
10
10
▲
Never walk or work under any raised boom or cutterhead. The boom could fall and
cause serious bodily injury or death. Always lower the boom and cutterhead flat on the
ground or support the boom and cutterhead on safety stands. Unload all hydraulic
actuators prior to doing any maintenance. Set the cutterhead on the ground, and then kill
the tractor engine. Push and pull the Control levers in and out several times to remove
pressure.
▲
Do not work under raised boom or cutterhead unless components are securely blocked
up to prevent inadvertent dropping
▲
Always read carefully and comply fully with the manufacturer’s instructions when
handling oil, solvents, cleansers and any other chemical agents.
▲
Always maintain the safety decals in good readable condition. If the decals become
damaged or unreadable, reorder them immediately.
▲
In addition to the design and configuration of this implement, including safety signs and
safety equipment, hazard control and accident prevention are dependent upon the
awareness, concern prudence, and proper training of personnel involved in the operation,
transport, maintenance, and storage of the machine. Refer also to safety messages and
operation instruction in each of the appropriate sections of the tractor and machine
manuals. Pay close attention to the safety signs affixed to the tractor and machine.
Although the information given here covers a wide range of safety subjects, it is
impossible to predict every eventuality that can occur under differing
circumstances whilst operating this machine. No advice given here can replace
‘good common sense’ and ‘total awareness’ at all times, but will go a long way
towards the safe use of your Spearhead machine
