Spearhead 8999082, Руководство пользователя

Страница: 16 / 21

Trident 7600HD
M M M Ma a a ac c c ch h h hiiiin n n ne e e e P P P Protection rotection rotection rotection
To prevent transmission damage, all rotors are protected with friction clutches, which
mounted on each drive shaft. When working under extreme conditions, s
where there are stumps, stones and other
so that the knife can easily escape if they hit objects on the ground. Above all, use caution.
The clutch settings should not be c
instructions. The compression spring of the fr
tightened, as this may cause serious damage to the transmission and the drive for which the
manufacturer excludes any liability.
If the device was not in operation for some time, there is a risk that the clutch p
together rust. Putting the device under any
operation, as in the case of the drive and the transmission are not protected against sudden
loads. In order to free the clutch plates, first remove all pressure spring b
the device for a short time, by deliberately trying to cause the clu
bolt to the original length. Take care that they are not over
If you are in doubt, please contact Customer Service or your loca
dealer to get more information.
Warni
Warni Warni
Warni
Before pe
the drive shaft, stop the tractor engine and remove the ignition key
before leaving the tractor cab.
Upon delivery of the unit, please check that the dealer has given the
correct information on the
send it to Spearhead.
16 16 16 16
Trident 7600HD
To prevent transmission damage, all rotors are protected with friction clutches, which
. When working under extreme conditions, such as in places
stumps, stones and other objects, it is advisable to reduce the engine speed
so that the knife can easily escape if they hit objects on the ground. Above all, use caution.
The clutch settings should not be changed without reading the operating and maintenance
instructions. The compression spring of the friction clutches (Fig. 8) must never be over
tightened, as this may cause serious damage to the transmission and the drive for which the
manufacturer excludes any liability.
If the device was not in operation for some time, there is a risk that the clutch p
together rust. Putting the device under any of these circumstances in this case
as in the case of the drive and the transmission are not protected against sudden
loads. In order to free the clutch plates, first remove all pressure spring bolt
the device for a short time, by deliberately trying to cause the clutch to slip. Finally, reset the
the original length. Take care that they are not over-stressed.
If you are in doubt, please contact Customer Service or your local Spearhead Spearhead
dealer to get more information.
Figure 8 slip clutch
Warni
Warni Warni
Warning
ng ng
ng
Before performing any maintenance or repair work, first disengage
the drive shaft, stop the tractor engine and remove the ignition key
before leaving the tractor cab.
Upon delivery of the unit, please check that the dealer has given the
correct information on the warranty. Fill in the registration card and
send it to Spearhead.
To prevent transmission damage, all rotors are protected with friction clutches, which are
uch as in places
reduce the engine speed
so that the knife can easily escape if they hit objects on the ground. Above all, use caution.
the operating and maintenance
iction clutches (Fig. 8) must never be over-
tightened, as this may cause serious damage to the transmission and the drive for which the
If the device was not in operation for some time, there is a risk that the clutch plates
of these circumstances in this case
as in the case of the drive and the transmission are not protected against sudden
olts and speed up
tch to slip. Finally, reset the
l Spearhead Spearhead
nce or repair work, first disengage
the drive shaft, stop the tractor engine and remove the ignition key
Upon delivery of the unit, please check that the dealer has given the
warranty. Fill in the registration card and