Spearhead 8999082, Руководство пользователя, Страница: 12 / 21

Trident 7600HD
Settings Settings Settings Settings
Height Adjustment Height Adjustment Height Adjustment Height Adjustment
To obtain the desired cutting height, the two adjusting seated on the rear part side pan
accordingly. Fine adjustment of the cutting can be achieved by shortening or lengthening
top link between the tractor and
Figure 3: Height adjustment of the rollers
Operation
Operation Operation
Operation
To avoid damage to the device, the c
low PTO speed. The rotational speeds of the device will be slowly increased to a default
speed of 1000 rev / min. If sometime heavy vibration, the engine is immediately shut down
and consider whether hammer knives are missing. In reviewing the safety regulations are
adhered to! Thus, other parts are not damaged, the cause must be determined and to fix the
error immediately.
The unit must be lowered to the ground before starting work. The total weight
rear wheels so that the device can foll
by the vegetation density, engine strength and adapting the site. Special attention is required
when turning in particular embankments. If the radi
not be raised. This is only required for tight turns or reverse travel
The working result depends on the fo
fast pace, however, can be man
In extreme conditions or if there is danger, on tree stumps to make large stones and
other hard objects, throttling the engine speed
hammer knives are not as strongly affected and
12 12 12 12
Trident 7600HD
To obtain the desired cutting height, the two adjusting seated on the rear part side pan
accordingly. Fine adjustment of the cutting can be achieved by shortening or lengthening
top link between the tractor and mower (Fig. 3).
Figure 3: Height adjustment of the rollers
To avoid damage to the device, the connection of the power transfer may take place only at
low PTO speed. The rotational speeds of the device will be slowly increased to a default
speed of 1000 rev / min. If sometime heavy vibration, the engine is immediately shut down
ammer knives are missing. In reviewing the safety regulations are
adhered to! Thus, other parts are not damaged, the cause must be determined and to fix the
The unit must be lowered to the ground before starting work. The total weight
rear wheels so that the device can follow the ground profile. The tractors speed is
the vegetation density, engine strength and adapting the site. Special attention is required
when turning in particular embankments. If the radius is large enough, the apparatus need
not be raised. This is only required for tight turns or reverse travel in dense ground cover.
The working result depends on the forward speed from, ie, slow speed allows finer cut, at a
fast pace, however, can be managed more.
In extreme conditions or if there is danger, on tree stumps to make large stones and
other hard objects, throttling the engine speed back is recommended so that the
not as strongly affected and damage is limited.
To obtain the desired cutting height, the two adjusting seated on the rear part side panels
accordingly. Fine adjustment of the cutting can be achieved by shortening or lengthening the
onnection of the power transfer may take place only at
low PTO speed. The rotational speeds of the device will be slowly increased to a default
speed of 1000 rev / min. If sometime heavy vibration, the engine is immediately shut down
ammer knives are missing. In reviewing the safety regulations are
adhered to! Thus, other parts are not damaged, the cause must be determined and to fix the
The unit must be lowered to the ground before starting work. The total weight must be on the
speed is regulated
the vegetation density, engine strength and adapting the site. Special attention is required
us is large enough, the apparatus need
dense ground cover.
allows finer cut, at a
In extreme conditions or if there is danger, on tree stumps to make large stones and
is recommended so that the