SP Scientific FTS FLEXICOOL IMMERSION COOLERS FC100, Руководство оператора

Страница: 33 / 38

Rev 001, 10/13 25
© SP Scientific 2013
Appendix
B
Appendix B: Changing Temperature
Display
DO NOT SET THE SETPOINT LOWER THEN -95 °F (-70.6 °C) OR ABOVE 68 °F (20 °C)
To change the SOLO Control
ler’s temperature display from degrees C to degrees F:
Press the SET and Rotate buttons on the SOLO controller at the same time to 1.
unlock the controller.
Note: The Set button is used to confirm the setting value. It is also used to navigate
between function modes. The Rotate button is used to change parameters within each
function mode.
Hold the SET button for 3 seconds to access the Initial Setting Mode. 2.
Press the Rotate button until you access the Temperature units menu setting 3.
( i.e., ).
Use the Down and Up buttons to change between degrees C or degrees F. 4.
Note: The Down button is used to decrease the value shown on the SV display.
Pressing and holding this button will accelerate the pace at which descending
increments are displayed. The Up button is used to increase the value shown on the
SV display. Pressing and holding this button will accelerate the pace at which
ascending increments are displayed.
Press the SET button to save. 5.
Press the Rotate button until you access Temperature Range High 6.
( i.e., ).
Use the Down / Up buttons to change the setpoint to 86 °F. 7.
Note: Refer to the chart below for span limits, setpoint recommendations and
overtemp safety.
Press the SET button to save. 8.
Press the Rotate button to until you access Temperature Range Low 9.
( i.e., ).
Down and Up buttons
Rotate button
SET button