SP Scientific FTS FLEXICOOL IMMERSION COOLERS FC100, Руководство оператора

Страница: 25 / 38

FTS Systems FlexiCool SOLO4848 Controller
Rev 001, 10/13 17
© SP Scientific 2013
Multiple Machine / Controller Setup
Using the optional Communication Kit or through RS485/Modbus communication,
SOLO controllers may
be wired together “daisy chained” to form a communication
network. This communication network allows for remote control, monitoring and/or
data logging through a single computer. The SOLO controller can be configured with
up to 247 unique addresses, which allows multiple machines to be monitored through
a single computer, however the monitoring software can only view up to four (4)
controllers at a single time.
Notes: For more information on the optional Communication Kit (p/n COMMKIT) refer to your
unit specifications or contact SP Scientific.
For more information on RS485/Modbus communication, contact SP Scientific.
Connection Procedure
Connect your PC to the communication port on the front of the first machine. 1.
Connect the back of the first machine to the front of the second machine 2.
using a standard (straight thru) RJ12 or RJ45 cable assembly.
Note: A 5-foot, straight, RJ12/45 (p/n 100004626) is available. For more
information, contact SP Scientific.
Connect each additional machine in the same “daisy chain” fashion.
3.
Note: Each machine on the network must be given a unique address. If four (4) or
more machines are on the network, you may need to add a terminating resistor (120Ω)
to the last unit.
Controller Setup
Press and hold the SET button ( ) for 3 seconds to enter the Initial 1.
Settings Mode.
Press the Rotate button ( ) 12 times to reach the Network Address 2.
feature C-no ( ).
Press the up or Down buttons ( ) to select a unique address for 3.
each controller in the network.
Press the Set button twice to save the value. 4.
Communication
Port (Back)
Communication
Port (Front)