Southern Cross JCD-900 Series, Инструкция по эксплуатации

Страница: 7 / 39

LGCY Series Page 5
K. Ensure that the surrounding area is kept clear of loose debris, rubbish and other inflammable rubbish
near the compressor.
L. During maintenance activities open all doors to prevent combustible vapour / fumes from
accumulating.
M. Do not place the compressor near or under vegetation to prevent contact with hot exhaust gases and
or exhaust components.
N. The anti-freeze agent used for some anti-freeze systems contains flammable methyl alcohol. Keep
ventilated and isolate any open flame when using or adding such type of anti-freeze agent. Such type of
system or agent cannot be exposed in the environment with the temperature higher than 66
℃
. The
specific gravity of anti-freeze agent vapour is greater than the air. Do not store such type of product
where insufficient ventilation is available. Do not directly expose the anti-freeze agent or container
under the sunlight.
O. All flammable liquid shall be stored at a place far away from the working site. Get familiar with the
extinguisher position, type and using method. Check the conditions of fire extinguishing system.
2.5 Moving Components
A. Hands, arms, other body parts and clothing must stay clear of the cooling fan and other moving
components. Enclosure doors and panels must be securely fastened to ensure the safety of operators.
B. Do not operate the compressor after the protective cover of fan or other components is removed.
C. Wear appropriate personal protective equipment whilst operating this equipment particularly near hot
surfaces or moving components.
D. Close the door on the unit when the maintenance is not carried out.
E. Ensure no one is in the unit and all doors and panels are closed and in place prior start-up.
F. The following operations can be made only after shutdown: filling fuel oil, cooling liquid, lubricating
oil, replacing battery or diethyl ether tank, etc.
G. Disconnect the battery before carrying out any maintenance, to avoid accidental start-up of engine.
After disconnection, make a clear identification to prevent reconnection by others.
H. Keep the ground near the control component and unit clean, and timely clean the oil and water stain
to prevent slipping or fall-off.
2.6 Hot Surface and Sharp Angles
A. Do not contact hot oil, cooling liquid and hot surface. Please note not to touch the sharp angles.
B. Do not directly face the exhaust port of compressor and diesel engine with any part of your body.
C. Wear the protective article such as gloves, working clothes and helmet during operation or
maintenance.
D. First-aid kit shall be provided. The injured should be treated immediately. Do not ignore small
scratches and burns that may cause infection.