South-Tek Systems BEERBLAST 14KPH, Руководство по эксплуатации и техническому обслуживанию

Страница: 20 / 45

BeerBlast™ 7/14KPH & N
2
-GEN
™ 7/14KPH O&M
South-Tek Systems
20
4.7
INSTALLATION (
BEERBLAST™ 14KPH / N
2
-
GEN™ 14KPH)
The
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH needs to be installed on a hard flat surface capable of supporting 300+
lbs. There are (4) anchor bolt holes on the support legs that can be used to secure the unit to the floor. It is not
required to be anchored, but always follow any site/local codes regarding securing equipment. The unit’s back side
and right side can be pushed all the way against the wall. Leave at least 6” on the left side of the cabinet for
ventilation, but
36” is recommended for access to the control panel (otherwise, the unit will need to be pulled out to
read the display. There are also two ¼” OD drain ports are on the left side of the cabinet. These can be plumbed to
the nearest site drain. The front sid
e of the cabinet requires 36” minimum to gain access to the front door and
perform routine maintenance. Leave enough clearance room on the top of the cabinet for gas line connections. The
N
2
-
GEN™ 14KPH will have the first 3 ports plugged as there is not an internal blender.
Ports on the upper cabinet are as follows (from left to right): Port 1: 60/40 CO
2
/N
2
Blend, Port 2: CO
2
In, Port 3:
25/75 CO
2
/N
2
Blend, Port 4, N
2
Out.
First-time use will require an initial pressurization of the internal storage tank. To perform this task, make sure that
all gas connections are properly made to the kegs. All gas connection ports are ¼” NPT female.