South-Tek Systems BEERBLAST 14KPH, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 45

BeerBlast™ 7/14KPH & N
2
-GEN
™ 7/14KPH O&M
South-Tek Systems
12
4.2
UNPACKING AND PREPARATION (
BEERBLAST™ 14KPH / N
2
-
GEN™ 14KPH)
The
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH will arrive in a wooden crate. Open the side noted, “Open this side”.
Once the crate is opened, inspect all parts for any damage upon receipt. Take any pictures upon arrival of the
crate, of damages done during shipping. Identify and verify that all parts listed on the packing list are present and
undamaged. South-Tek Systems (STS) is not responsible for damages that have occurred during the shipping and
handling of the
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH. Any visual damages should be immediately documented
and reported to the shipping company responsible. Then, contact STS at (888)526-6284 to assess the damages
only after the shipping company has been notified.
Until Installation:

The
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH can be stored inside the wooden crate until installation. For
extended storage of over a month, open and insert desiccant bags as needed to prevent moisture buildup.

Store the
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH in a dry and climate controlled (60-80°F) room.

Always keep the
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH in an upright position.

Do not connect the AC power cable until this manual has been read completely and all connections are made
as stated within.

Keep all gas lines dry so you don’t get moisture in the generator upon hookup.

Never place/stack objects on top of the
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH.
To remove the
BeerBlast™ 14KPH / N
2
-
GEN™ 14KPH from the crate, unbolt the cabinet base from the crate.
Carefully, lift the unit from the crate and set it on the floor. The use of a floor jack is advisable to move it to the final
location. Once in place, unbolt the 4 colored bolts at the bottom of the cabinet.
Carefully, break down the crate and store in a safe location in the case that it may need to be sent back to the
factory for service.