Ui24R User Manual
7.2: DELAY
FX EDIT > DELAY
7.2: DELAY
Delays repeat a sound a short time after it first occurs. Delay becomes echo when the output is fed back into
the input (feedback). This turns a single repeat into a series of repeats, each a little softer than the last
. The Ui
delay time is set in Milliseconds or in musical values. Press the DIV display to access a drop down box with the
available musical note values. Press the TAP TEMPO button repeatedly to tap in the desired delay time. (This is
usually done in time with the music.) Press and hold the TAP TEMPO button to manually type in the delay time
in BPM.
TIME
Delay Length
Delay time set in milliseconds.
TAP / BPM
Delay Tempo
A delay time setting that uses a ‘tapped’ tempo as a guide. Tap the ‘TAP TEMPO’ button to set the delay
time.
The TAP TEMPO button is also available in the control software SlideOut panel.
DIV
Length Subdivision
Delay time set as a musical sub-division of the tempo. Press the DIV display to access a drop down box with
the available musical note values.
FBACK
Controls the number of delay repeats by feeding the delay output signal back into the delay input
This creates a series of delay repeats, each slightly attenuated until they become inaudible. Higher settings
create more repeats; lower settings reduce the number of repeats. When this knob is turned fully clockwise,
it engages Repeat Hold – delay repeats play back in an infinite loop, but no further input signal is introduced
into the delay effect. Repeat Hold is available only on Studio, Mono and Pong Delay.
LPF
Low Pass Filter - Frequencies above this are filtered / removed
Cut the high frequency content by adjusting the cut-off frequency of a shelving filter.
