
13
Operation
E.2 Commissioning help
E.3 Free commissioning
If you decide not to use the commissioning help, you should make the necessary set
-
tings in the following sequence:
- Menu 10.
Language
- Menu 3.
Time, date and operating times
- Menu 5
Settings for heat circuit, all settings
- Menü 6.
Protective functions if necessary
- Menü 7.
Special functionsif necessary
Finally, menu 4.2 under operating mode „Manual“ should be used to test the switch out
-
puts with the consumers connected, and to check the sensor values for plausibility. Then
switch on automatic mode.
tions of each parameter in the display. Pressing the „esc“ key takes you back to the
previous value so you can look at the selected setting again or adjust it if desired. Pres
-
sing the „esc“ more than once takes you back step by step to the selection mode, thus
cancelling the commissioning help. Finally, menu 4.3 under operating mode „Manual“
should be used to test the switch outputs with the consumers connected, and to check
the sensor values for plausibility. Then switch on automatic mode.
The first time the controller is turned on
and after the language and time are set, a
query appears as to whether you want to
parametrise the controller using the com-
missioning help or not. The commissioning
help can also be terminated or called up
again at any time in the special functions
menu. The commissioning help guides you
through the necessary basic settings in the
correct order, and provides brief descrip-
Caution
Observe the explanations for the the individual parameters on the follo-
wing pages, and check whether further settings are necessary for your
application.
Caution
Observe the explanations for the the individual parameters on the follo-
wing pages, and check whether further settings are necessary for your
application.