26
Chapter 2 Installation
2
Check whether the erase-protection tab is set to the write-enable position.
If the tab is orange, data can be written to the cartridge.
Setting the Cartridge
Set the cartridge into the AIT library. When setting the cartridge, specify the slot
by its element address. For information about element addresses, refer to
“Assigned Element Addresses” (page 48) in Chapter 3, “Basic Usage”.
1
At the status display, press the [MENU] button for two seconds.
2
Use the
V
and
v
buttons to select “2.Eject/Insert”, then press the [ENTER]
button.
“Eject/Insert” appears.
3
Select “3.Insert Into Library”, then
press the [ENTER] button.
4
Select the cartridge insertion
method, then press the [ENTER]
button.
• When you want to specify a slot
and insert the cartridge in it, select
“1. Single Mode”.
• When you want to insert several
cartridges consecutively, select
“2. Multiple Mode”. In this case,
you only need to specify the first slot.
5
Use the
V
and
v
buttons to set the
element address of the slot where
the cartridge is going to be set, then
press the [ENTER] button.
If the tab is lowered, data can be
written to and erased from the
cartridge.
j
If the tab is raised, data cannot be
written to or accidentally erased
from the cartridge.
J
AIT-1
Lid
If the tab is moved to the left, data
can be written to and erased from
the cartridge.
K
If the tab is moved to the right, data
cannot be written or accidentally
erased from the cartridge.
k
Lid
AIT-5, AIT-4, AIT-3 Ex, AIT-3, AIT-2 Turbo,
AIT-2, AIT-1 Turbo, AIT-E Turbo
Eject/Insert 12:34
1.Eject From Library
2.Eject From Drive
3.Insert Into Library
Insert 12:34
1.Single Mode
2.Multiple Mode
Slot 01
