Sony QUALINA 004, Руководство пользователя

Страница: 15 / 46

28 29
Selecting the screen projection mode
You can enjoy various screen projection
modes according to the video signal
received. For details on the available video
signals, see page 42.
For details on operating the menu screen,
see “Using the menu” on page 30.
1 Press the MENU button.
The menu display appears.
2 Press the M or m button to select the
INPUT SETTING menu, then press the ,
or ENTER button.
3 Press the M or m button to select “Wide
Mode,” then press the , or ENTER
button.
����� �������
������ ���������
����
������
���� ����
����
��������
���� ���� ����� �����
����� ����
���� ���� ����������
���� �����
�������
4 Press the M or m button to select the
desired screen projection mode, then
press the
< or ENTER button.
Notes on changing the screen projection mode
This projector provides you with various choices of
screen projection mode. When selecting the screen
projection mode, consider the following:
• Selecting a screen projection mode may provide a
different look from that of the original image.
• If the projector is used for profit or for public
viewing, modifying the original picture by switching
aspects may constitute an infringement of the rights
of authors or producers that are legally protected by
copyright laws.
Projecting images (continued)
To turn off the power
1
Press the ? / 1 button on the remote or
control panel.
“Power OFF?” appears.
Note
• The message disappears if you press any button
except the
?
/
1
button on the remote or on the
control panel, or if you do not press any button
for 5 seconds.
2
Press the ? / 1 button on the remote or on
the control panel again.
The fan runs for several seconds to
reduce internal heat build-up.
3
Confirm that the ? / 1 indicator light is lit in
red.
If you operate the projector without
viewing the screen
If you operate the projector from a location
where you cannot view the on-screen
message, you can also turn off the power by
holding the
?
/
1
button for about one second.
Note
• The internal circuitry of the Direct Power On/Off
function may drive the fan for a short time even after
the
? / 1 button is pressed and nothing is displayed
on the information panel display.
Direct Power On/Off function
If you use a circuit breaker to turn the power
for the entire system on and off, set the
direct power on function to “On” (see page
50). When you turn the power off, you can
also just unplug the power cord without
pressing the
? / 1 button. The internal circuitry
will cause the fan to automatically operate
for a short while, even after the power cord
is removed. However, if the unit has been on
for less than 15 minutes, follow the
procedure for turning off the power as
described in “To turn off the power.”
Pr
ojecting images