Sony PDW-U4, Руководство по обслуживанию

Страница: 63 / 156

60
Continued
Main
Code
Sub
Code
ERROR/ALARM indicator Description Error remedy method Refer to section
Lighting
interval
Switching off
condition
95 A07 0.25 seconds Power Head data cannot be read
from the EEPROM in
optical block assembly
0Bch.
1. After the optical block assembly or the BD-48 board is replaced, perform
“Action after replacement or repair”.
2. Check the optical block assembly installation status.
“4-5. Optical Block
Assembly”
“4-11-1. BD-48 Board”
A0A 1 second Power A mismatch of OP ID was
detected in the hours
meter data on the 0Bch
side and the EEPROM
data of the optical block
assembly 0Bch.
A30 0.25 seconds Power There is no response from
the optical block
assembly 0Bch.
A40 0.25 seconds Power The IL adjustment of the
optical block assembly
0Bch has not been
completed.
A42 1 second Power Disc Drive LSI 0b
(IC100: BD-48 board)
cannot write data to the
FLASH-ROM (IC101:
BD-48 board) or the SE
EEPROM (IC3:
SE-1004A board).
1. After the SE-1004A board or the BD-48 board is replaced, perform
“Action after replacement or repair”.
2. Check the SE-1004A board installation status.
“4-11-7. SE-1004A Board”
“4-11-1. BD-48 Board”
A60 0.25 seconds Power A system error has been
detected in the disc drive
of LSI 0b (IC100: BD-48
board).
1. Eject the cartridge.
2. Acquire the drive/driver log.
3. Turn off the unit.
4. Turn on the unit and insert the same cartridge.
• In the case no error occurs:
The problem is fixed. Use the unit as it is.
• In the case the error occurs:
The drive may be defective.
Send the acquired drive/driver log to your local Sony Sales
Office/Service Center.
－
A61 0.25 seconds Power A servo firmware
communication error was
detected in Disc Drive
LSI 0b (IC100: BD-48
board).