A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the System — System Menu
41
Select
ON
in the case of IEEE802.3at compatible power
adjustment by PSE (Power Sourcing Equipment).
Notes
• Before setting, check the specifications, power level
and settings of the PSE you are going to connect.
• If the PSE with which you will use this unit cannot
supply sufficient power and you set the HPoE LLDP
function to
Off
, the unit may not operate correctly.
• The HPoE LLDP function may be slow to start if the
LLDP function is set to
ON
and PSE is not used for
some LLDP functions.
Eflip
You can display flip vertical images on the computer.
Select
Off
when you hang the camera from a ceiling.
Select
On
when you install the camera on a rack, etc.
Note
Panorama images, thumbnails set in the Preset Setting
menu, privacy mask positions and motion detection
areas, etc., will not be inverted, even if the
On
/
Off
setting of the inverted image is switched. To invert the
image, make the setting again.
Video out (SNC-ZP550/ZR550)
Set the video output from the BNC cable connected to
the SLOC port. When outputting video images, select
On
.
Note
• The format for video output signals varies depending
on the
Camera operating mode
setting. In
Camera
operating mode
,
30 fps
is for NTSC and
25 fps
is for
PAL.
• When
Video out
is set to
On
, the motion detection
function and
Image 2
of
Video codec
will not be
available.
Stabilizer (SNC-EP520/EP521/ER520/
ER521/ER585/ER585H)
Set
Stabilizer
. When you select
On
, the camera image
vibration will be reduced on the place where this unit is
installed with vibration.
Note
• When
Stabilizer
is set to
On
, the shooting angle of
view will be narrowed by 20%.
Using preset or cropping functions (SNC-ER585/
ER585H) will also narrow the shooting angle of view.
• If
Stabilizer
is set to
On
, the compensation will not be
effective depending on vibration.
• It will take some time before the effect of the
compensation appears after operating the camera’s
pan, tilt or zoom functions.
• Since the SNC-ER585/ER585H models integrate the
rolling shutter and CMOS sensor, focal-plane shutter
effects may occur when using the stabilizer function.
OK/Cancel
See “Buttons common to every menu” on page 35.
Initialize Tab
Display sample: SNC-ER580
Reboot
Used when rebooting the system.
Click
Reboot
, and the message “This System will be
rebooted. Are you sure?” appears. Click
OK
to reboot
the camera. It takes about two minutes to restart.
Factory default
Resets the camera to the factory settings.
Retain current network settings
When this item is checked, only the current network
settings will be retained after reset.
Click
Factory default
, and the message “Setup data will
be initialized. Are you sure?” appears. When you click
OK
, the network indicator on the camera starts to blink.
After adjustments of the default settings have finished,
the camera reboots automatically. Do not turn off the
camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of this unit while pressing the reset
