6-123
HVR-S270J/S270U/S270N/S270E/S270P/S270C
3-6.
TIME CODE SYSTEM ADJUSTMENTS
Set the switches to the following positions unless otherwise speci-
fied.
1.
Time Code Output Check
Mode
VTR playback (VCR mode)
Signal
Time code recorded tape
Measurement point
Counter value of timer code reader
Measuring instrument
Specified value
The counter value on the LCD panel
must be same as the value indicated
on the time code reader.
Switch setting
TC/U-BIT button ....................................................................... TC
Connection of equipment
Checking method:
1) Connect the time code reader (such as DSR-45) to the TC OUT
terminal.
2) Check that the counter value on the LCD panel is same as the
value indicated on the time code reader.
Time code reader
1H 09M 40S
HVR-S270
TC OUT
18. Recording and Playing Check
Mode
CAMERA and VCR mode
Signal
Test tone generation
1 kHz, –20 dBFS signal (NTSC model)
1 kHz, –18 dBFS signal (PAL model)
Measurement Point
Audio L and R terminal of AUDIO
OUT jack (CH1, CH2, CH3, CH4)
Measuring Instrument
Oscilloscope
Specified value
No abnormality in played back
sounds
Menu setting
1) COLOR BAR (CAMERA SET menu (CAMERA mode))
TONE ................................................................................. ON
2) HDV 2CH/4CH (AUDIO SET menu
(CAMERA mode)) .......................................................... 4CH
3) VCR HDV/DV (IN/OUT REC menu (VCR mode)) ... AUTO
Switch setting
1) OUTPUT switch ........................................................... BARS
Note:
After the tape recording finished, return the switch to CAM.
2) AUDIO MONITOR switch .......................... CH1/2 or CH3/4
Checking method:
1) Record the test tone.
2) Playback the recorded section.
3) Set the AUDIO MONITOR switch to CH1/2. Observe the out-
put waveform of CH1 at Audio L terminal with oscilloscope
to check that no abnormality is found in the played back sounds.
4) Observe the output waveform of CH2 at from Audio R termi-
nal, perform checking in the same manner.
5) Set the AUDIO MONITOR switch to CH3/4. Observe the out-
put waveform of CH3 at from Audio L terminal, perform check-
ing in the same manner.
6) Observe the output waveform of CH4 at from Audio R termi-
nal, perform checking in the same manner.
