Sony DNW-A28, Руководство по эксплуатации

Страница: 23 / 102

Chapter 2 Preparations
Chapter 2 Preparations
2-5
To record with this unit, you can use half-inch width
Betacam SX S cassettes, Betacam SP S cassettes
(metal tape), or UVW S cassettes (metal tape).
The number in the model name of the cassette
indicates the cassette’s normal recording time in
minutes (for example, 12 minutes in the case of the
BCT-12SX). However, when you are using Betacam
SP S cassettes and S cassettes for UVW VTRs on this
unit, you can record up to twice the amount of time
indicated on the cassette (see the table below).
Usable Cassettes
Notes
• Digital Betacam cassettes cannot be used.
• Oxide tapes recorded in the Betacam format and
metal tapes recorded in the Betacam SP format can
be only played back.
2-3-1 Loading/Ejecting
Cassettes
To load a cassette
1
Set the POWER switch to ON.
1
2
2
Load a cassette in the direction shown in the figure
after checking the following points.
• That “ERROR-10” is not displayed in the FL
display panel.
• That there is no slack in the tape.
If “ERROR-10” appears in the FL display panel
This means that there is condensation inside the unit.
For the steps to take in this case, see “Moisture
Condensation” (page A-3).
If there is slack in the tape
Take up the slack by rotating the reels in the directions
shown by the arrows in the figure, keeping one reel
fixed by pressing it with your finger as you rotate the
other reel.
The reels stop rotating when there is no more slack.
To eject the cassette
1
With the unit powered on, press the EJECT button.
A part of the cassette comes out from the unit.
2
Take out the cassette.
Note
The EJECT cannot be used to eject a cassette when
battery power falls to below about 9 V. Remove the
cassette manually (see next page).
2-3 Handling Cassettes
Betacam SX
BCT-6SX/12SX/22SX/32SX/
60SX
Betacam SP (metal tape) BCT-5MA/10MA/20MA/30MA
(Recording time: 10/20/40/60
minutes)
UVW (metal tape) UVWT-10MA/20MA/30MA
(Recording time: 20/40/60
minutes)