Sony DNW-A28, Руководство по эксплуатации

Страница: 30 / 102

Chapter 2 Preparations
2-12
Chapter 2 Preparations
2-6 Setting Timecode
There are four ways to record timecode.
(1) Record the output of the internal timecode
generator with setting an initial value.
(2) Record the output of the internal timecode
generator, which has been synchronized with an
external timecode generator.
(3) Record the output of the internal timecode
generator, which has been synchronized with
playback timecode. (This method is always used
during editing.)
(4) Record the output of an external timecode generator
without regeneration.
For more information about timecode generator settings,
see the setup menu “Item 600 series: timecode generator
settings” (page 6-14).
For more information about playback timecode settings, see
page 4-4.
In addition to the INT/EXT switch and the PRESET/
REGEN switch, the following settings are made with
submenus.
• VITC ON/OFF: (home page)
• VITC/LTC/AUTO: (home page)
• DF/NDF (525 mode): (general settings page)
For more information about submenus, see section 2-7-1
“Displays on the Home Page of the Submenu”.
INT/EXT switch PRESET/REGEN switch
(1) PRESET
(2)
INT
EXT
(3) INT
(4) PRESET
PRESET
PRESET
2-6-1 Setting an Initial Value and
Recording Timecode
Set the switches and submenu items as shown below.
Submenu settings
To set an initial timecode value
Perform the following procedure.
1
Press the CTL/TC/U-BIT button and select TC.
INT/EXT: INT
PB
4 3
3
INT
EXT
PRESET
REGEN
F-RUN
R-RUN
TC GENERATOR
PRESET/REGEN: PRESET
F-RUN/R-RUN: Either
position
Item Setting
VITC ON/OFF (home
page) Desired setting (ON for
recording)
VITC/LTC/AUTO (home
page) No setting required (ignored)
DF/NDF (general settings
page) Desired setting (in 525 mode)
RESET button
00
:
00
:
00
:
00
AU-1 AUTO VITCON SDI
TC 525 SX-- BATT
1
2
3,4,5
6