Sony DFS-900M, Руководство по эксплуатации

Страница: 88 / 221

88
Basic Switcher Settings
Ch
apt
er 3 Prep
ar
at
ion
s
1
When using the BKDF-901: If the SHIFT button of the DME/SETUP
block is not lit, press it to light it.
When using the BKDF-902: Skip to step
2
.
2
Press the INPUT button.
A settings sub menu of the Input sub menu appears in the display panel.
3
Press the
h
or
H
button in the numeric keypad until the Input Process1
or Input Process2 sub menu appears, depending on what you want to adjust.
“Input Process1” or “Input Process2” appears in the sub menu title display
area. If the title you want is already displayed there, you can skip this step.
Example with “Input Process1” displayed:
4
When using the BKDF-901: Press the PRESET selection button that
selects the input you want to set.
If you want to set an input that has been assigned by using the SHIFT
button
(see page 76) , press the SHIFT button before pressing the
PRESET selection button.
When using the BKDF-902: Press the M/E bus B selection button or the
PRESET bus selection button that selects the input you want to set.
If you want to set an input that has been assigned by using the SHIFT
button
(see page 76) , press the SHIFT button before pressing the M/E
bus B selection button or the PRESET bus selection button.
5
Rotate the F1 to F4 knobs to make the settings.
The signal characteristics set by the sub menus and the correspondence
between knobs and parameters are as follows.
Input Process1 sub menu
Input Process2 sub menu
Knob Parameter Description Setting range
F1 WClp Set the white clip level 50.0 to 109.0
F2 BClp Set the black clip level –7.0 to 50.0
F3 LGN Set the luminance signal gain 0.00 to 200.00
F4 Set Adjust the black signal level 0.0 to 100.0
Knob Parameter Description Setting range
F1 CClp Set the chroma signal clip level 50.0 to 111.0
F2 CGN Set the chroma signal gain 0.00 to 200.00
F3
H Phase Trim
a)
Adjust the horizontal phase
a)
–4 to 4