Sontex Supercal 5 I, Инструкция по эксплуатации

Страница: 42 / 68

42 Instruction for use | Supercal 5
6.12 Sealing
The sealing concept is subject to country-specific regulations. The sealing scheme shown
here is built in to the Supercal 5 I.
Ex factory the Supercal 5 I is unsealed. The following installation steps must be carried out:

Installing it to its final operating location

Installing the two temperature sensors

Installing the power supply if required

Connecting the flowmeter to the Supercal 5 I
Then the Supercal 5 I must be sealed by using the menu on the display according to chapter 7.
The installer can modify any other metrological parameter with Superprog Android and
Superprog Windows at any time.
Once the unit is sealed, in order to return to commissioning mode or to the
un-sealed state,
the seal must be broken as pictured below:
6.13 Nowa / Unicon
See chapter 11.11 Nowa/Unicon
6.14 Save Operating Data
6.14.1 Data Backup
The Supercal 5 has a non-volatile FRAM for data storage.
The data is thus retained even in the event of a power failure. All values are automatically
updated and saved.
The historical data is organized in:

Four totalizers

One average value

One maximum value

One historical event
For each set of historical data, some customization is available:

Maximum number of records

Recording frequency