Sontex Supercal 5 I, Инструкция по эксплуатации

Страница: 29 / 68

29 Instruction for use | Supercal 5
6. Operation
6.1 General Navigation
The menus can be accessed from the standard display using the control buttons. The Super-
cal 5 has the following menus (press LEFT and RIGHT buttons at the same time)
1. Main Menu (data relevant for billing)
2. Metrological
3. Configuration
4. Service
The first time you power on the display, or after 3 minutes of inactivity you will see the Error
menu if any error event occurred. If there were no errors, the screen will display the “Cumu-
lated Energy” menu. This menu is the first one embedded into the Main Menu.
6.2 Standard Display
Large and clear LCD display for manual reading. The LCD display is structured as follows:
Note

After 3 minutes, the calculator display automatically switches back to
the main menu.
6.3 Control Buttons
The control key can be used to select and confirm the various menus, parameters or other
selection options within the display.
➔
Right Key
The Right key has two functions:

A single press selects next.

A two second press in the “Overview Menu” selects the highlighted menu.
➔
Left Key

Left key selects previous.

With any menu highlighted, pressing both the LEFT and RIGHT keys for two seconds, will
select the “Overview Menu”.
► Menu’s name
► M1: Module installed in slot 1
► M2: Module installed in slot 2
NOTICE

The safety and service marks relevant to calibration must not be damaged or
removed. Otherwise the warranty of the device is void. User seals may only be
removed by authorized persons for service purposes and must then be renewed.

Once the optional module has been installed, the Supercal 5 calculator must be
protected against unauthorised access with user seals.