Sole Diesel G-20M-15, Инструкция по эксплуатации

Страница: 27 / 40

ENG - 23
03917101G.ENG rev. 0
6. USING THE ENGINE
6.0 GENERAL WARNINGS
Refer to heading 1.3 for safety information.
6.1 START THE GET SET.
6.2 STOP THE GEN SET.
From MDA panel, push the red boton. Check the service manual attached.
To stop the get set from auxiliary panel, turn the key to left and (Pos. OFF).
6.3 USING THE ENGINE INFREQUENTLY
Take special precautions in installations where the engine must cut in rapidly and suddenly after long periods of inactivity
(emergency power systems, fire prevention systems and harsh ambient conditions).
For specific application conditions consult SOLÉ DIESEL.
6.4 OPERATING THE ENGINE AT LOW TEMPERATURES
Whenever the atmospheric temperature drops below zero, the following series of circumstances occur:
(1) The cooling liquids of the engine may freeze. (2) The lubricating oil becomes thicker.
(3) There is a grop in the voltage at the battery terminals. (4) The air inlet temperature is low and the engine has
difficulty in starting. (5) The fuel loses fluidity.
To prevent the damage caused by low temperature operation, the engine should be prepared as follows:
(1) Use anti-freeze as indicated in section 4.2.2 of this manual.
(2) When the engine is to be stopped, close the sea water cock, open the sea-water filter cover and start the engine adding
a mixture of fresh water and 30% anti-freeze until the sea-water circuit is filled completely. Stop the engine and replace
the sea-water filter cover. Before starting the engine again, open the sea-water cock. Repeat this operation whenever
the engine is used at temperatures below ºC.
(3) Make sure that the lubricant oil is good quality and has a suitable viscosity. SAE 10W/30 synthetic oil is recommended.
(4) Protect the battery against the cold, covering it with an adequate material. Check that the battery is fully charged. It is
also advisable to use a dielectric spray on the electrical connections.
(5) When starting the engine, make sure that the heating plugs become hot enough. Follow the instructions detailed in
section 6.1 of this manual.
(6) If necessary, to replace the fuel with a type more suited to low temperature operation. The accumulation of impurities in
the fuel tank could cause faulty firing.
To start get set from MDA panel (1st panel) is necessary to push the GREEN
boton. The get set spend 4-5 seconds to start. Check the service manual
attached. For installation double panel, is not possible start from MDA panel and
stop for the auxiliary panel. The MDA panel can be switch on to check the
values.
To start from AUXILIARY panel, turn the key to right hand (Pos. RUN) and
pusch the boton named “CRANK”. Use the pre-heating bottom only during 4-5
seconds