Connection Steps:
Step1
. Prepare EPS wires.
3.1 Choose the appropriate wire(cable size: refer to picture below).
3.2 Reserve about 60mm of conductor cross-sectional area.
3.3 Remove 12mm of insulation from the end of wire.
3.4 Insert stripped wires into AC terminal and insure all conductor strands are captured in
the AC terminal.
3.5 Crimp the AC terminal head by using a crimping pliers and screw down screw cap tightly.
Step2
. Insert EPS cable into EPS port through screw cap and then tighten it.
Insert L1,L2,L3 wire, N wire and PE wire( PE wire does not applies to Australia)
into corresponding ports of EPS terminal and screw them tightenly.
(Slotted screwdriver. Torque:1.2
±
0
.
1Nm)
Ø
Requirements for EPS load
Ø
Please make sure the EPS home load power is always within the
EPS output rating. Please be aware that it will also be limited by the
battery installed. Less batteries will result in less EPS output power.
When an “over load” occurs, please adjust the EPS loads to make
sure it is within the EPS output power range, then turn the inverter
back on.
For the nonlinear load, please make sure the inrush power should
be within the EPS output power range.
Warning
!
Below table shows some common feasible loads for you reference.
Type
Power
Start Rated
Common
equipment
Example
Resistive
load
Inductive
load
Capacitive
load
X 1
X 2
X 1
X 1.5
X 3
~
5
X 2
Start
Rated
100VA
( W )
100VA
( W )
80VA
( W )
60VA
( W )
450-750VA
(W)
300VA
(W)
Equipment
Fluorescent lamp
Fluorescent lamp
40W
Fan
Fridge
Fridge
150W
Incandescent
lamp
T V
Incandescent
lamp
100W
Electrical Connection
Electrical Connection
26
27
for AU/NZ
for AU/NZ
Step2
.
Note: Connect PE wire into
PE port at right side !
Note: The right most port
should not be connected !
Step1
.
for other
countries
for other
countries
Table 5 Cable and Micro-breaker recommended
EPS Cable
≥
5mm
²
EPS breaker
≥
5mm
²
≥
5mm
²
≥
5mm
²
32A
32A
32A
32A
Model
L1
L2
L3
N
PE
60mm
12mm
L1
L2
L3
N
60mm
12mm
PE
L1
L2
L3
N
X3-Fit-8.0E
X3-Fit-8.0C
X3-Fit-10.0E
X3-Fit-10.0C
The slotted screwdriver .
Torque:1
.
2
±
0
.
1Nm
