5. Installation
5.1 Check for Physical Damage
5.2 Packing List
Make sure the inverter is intact during transportation. If there is any visible
damage, such as cracks, please contact your dealer immediately.
Open the package and take out the product, please check the accessories first.
The packing list shown as below.
Installation
Installation
Installation Precaution
X3-Retro Fit Series inverter is designed for outdoor installation (IP 65).
Make sure the installation site meets the following conditions:
Not in direct sunlight.
Not in areas where highly flammable materials are stored.
Not in potential explosive areas.
Not in the cool air directly.
Not near the television antenna or antenna cable.
Not higher than altitude of about 2000m above sea level.
Under good ventilation condition.
The ambient temperature in the range of -20
℃
to +60
℃
.
The slope of the wall should be within
±
5
°
.
The wall for mounting the inverter should meet conditions below:
1. Solid brick/concrete, or strength equivalent mounting surface;
2. Inverter must be supported or strengthened if the wall’s strength isn’t
enough(such as wooden wall, the wall covered by thick layer of decoration)
Please AVOID direct sunlight, rain exposure, snow laying up during installation
and operation.
5.3 Mounting
18
19
19
A
D
E
F
L
G
H
I
X3-Retro-Fit 8kW-10kW
J
K
O
Object
A
B
C
Inverter
Bracket
Expansion tubes & Expansion screws (5/5)
Description
H
I
J
K
L
Ring terminal (for grounding) (2)
User manual
Quick installation guide
M
Warranty card
Grounding nut
N
O
Wifi module (optional)
D
E
F
Battery connectors (1*positive, 1*negative)
G
AC terminals/EPS terminals (optional)/Earth terminals (12)
8 pin terminal for meter connection
Scotch tape(2) (optional)
X3-Retro Fit
User Manual
8.0kW - 10.0kW
M
B
C
Waterproof connector with RJ45 (2*RJ45)
N
NTC (optional)
